Solder Bridging
Solder bridging occurs when solder connects two adjacent pads or pins that should remain electrically separate. It is often caused by excessive solder paste, poor stencil design, component misalignment or an unsuitable reflow profile.
Prevention includes optimizing stencil aperture size, checking paste volume with SPI, maintaining accurate component placement and reviewing the reflow profile.
Insufficient Solder
Insufficient solder can result in weak joints or intermittent connections. Possible causes include blocked stencil apertures, low paste volume, poor pad design or component lead coplanarity issues.
Regular stencil cleaning, SPI inspection and incoming component checks help reduce this defect.
Tombstoning
Tombstoning occurs when one end of a small component lifts from the pad during reflow. It can be caused by unbalanced pad heating, uneven solder paste deposition, component placement offset or differences in pad size.
Balanced pad and stencil design, accurate placement and a controlled reflow profile are important preventive measures.
Missing or Misaligned Components
Missing components may result from feeder errors, nozzle pickup issues or programming mistakes. Misalignment can occur when placement coordinates, vision recognition or component dimensions are incorrect.
First-article inspection, feeder verification and AOI inspection help detect these problems before mass production.
Solder Voids
Voids are gas pockets trapped inside a solder joint. They can reduce thermal and electrical performance, especially in power devices and BGA packages.
Prevention includes controlling solder paste quality, optimizing the reflow profile, managing moisture-sensitive components and using X-ray inspection for critical joints.
Component Orientation Errors
Polarized components such as diodes, ICs and connectors must be placed in the correct orientation. Incorrect rotation can cause functional failure or damage during power-up.
Clear polarity markings in the design, accurate pick-and-place data and AOI checks help prevent orientation errors.
PCB Warpage
Board warpage can affect paste printing, component placement and reflow. It may be related to board thickness, copper balance, panelization or thermal stress.
Good panel design, balanced copper distribution and proper board support during production help maintain flatness.
Contamination and Handling Damage
Contamination, fingerprints, moisture and improper handling can affect solderability and product reliability. ESD damage may occur when boards are handled without proper protection.
Clean production areas, ESD controls and defined handling procedures are essential for sensitive electronic assemblies.
Prevention Through Process Control
PCB assembly defects are easier to prevent than to correct. It should combine stencil and paste control, SPI, accurate placement, reflow monitoring, AOI and X-ray inspection where required.
Heliance supports SMT and PCBA manufacturing for audio and consumer electronics. Contact us to discuss your assembly and quality requirements.
